Subaru Impreza 2003 Service Manual page 2241

3) Install the selected pinion height adjusting shim
on drive pinion, and press the rear bearing cone
into position with ST.
ST 498175500 INSTALLER
ST
4) Insert the drive pinion into differential carrier, in-
stall the previously selected bearing preload adjust-
ing spacer and washer.
(A)
(B)
(C)
(A) Drive pinion
(B) Bearing preload adjusting spacer
(C) Bearing preload adjusting washer
(D) Differential carrier
5) Press-fit the front bearing cone into carrier with
ST1, ST2 and ST3.
ST1 32285AA000 DUMMY COLLAR
ST2 399780104 WEIGHT
ST3 899580100 INSTALLER
ST3
ST1
ST2
REAR DIFFERENTIAL FOR VA-TYPE
DI-00085
(D)
DI-00156
DI-00087
DI-61
6) Insert the spacer, then press-fit the pilot bearing
with ST1 and ST2.
ST1 399780104 WEIGHT
ST2 899580100 INSTALLER
ST2
ST1
7) Fit a new oil seal with ST.
NOTE:
• Press-fit until the end of oil seal is 1 mm (0.04 in)
inward from end of carrier.
• Apply grease between the oil seal lips.
ST 498447120 INSTALLER
ST
8) Press-fit the companion flange with ST1 and
ST2.
NOTE:
Be careful not to damage the bearing.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
ST1
ST2
DIFFERENTIALS
DI-00088
DI-00089
DI-00090