Subaru Impreza 2003 Service Manual page 1597

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
2) Tighten the bolts and nuts.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
E
A
Bolt length mm (in)
(A) 12 (0.47)
(B) 40 (1.57)
(C) 45 (1.77)
(D) 62 (2.44)
(E) 73 (2.87)
3) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body using clips.
(C)
(A)
(G)
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) SPORT shift solenoid (Beige) (if equipped)
E
E
D
D
D
D
C
B
C
B
AT-00905
(B)
(D)
(E)
(J)
(I)
(H)
(F)
AT-00902
4) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
THREE BOND 1217B (Part No. K0877YA020)
5) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Fluid packing:
THREE BOND 1217B (Part No. K0877YA020)
6) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
7) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to 4AT-
31, Automatic Transmission Fluid.>
8) Check the ATF level. <Ref. to 4AT-31, Automat-
ic Transmission Fluid.>
2. ATF TEMPERATURE SENSOR
For installation of ATF temperature sensor, refer to
"Front Vehicle Speed Sensor." <Ref. to 4AT-53, IN-
STALLATION, Front Vehicle Speed Sensor.>
4AT-65
AUTOMATIC TRANSMISSION
AT-00051
AT-00052