Subaru Impreza 2003 Service Manual page 2300

DRIVE SHAFT SYSTEM
10) Install the disc brake caliper on back plate.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
11) Adjust the parking brake lever stroke by turning
the adjuster.
12) While applying the parking brake, tighten a new
axle nut using a socket wrench. Lock the axle nut
after tightening.
Tightening torque:
186 N·m (19 kgf-m, 137 ft-lb)
CAUTION:
Do not overtighten it as this may damage the
wheel bearing.
13) Install rear ABS wheel speed sensor.
(1) ABS wheel speed sensor
14) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
90 N·m (9.2 kgf-m, 66 ft-lb)
15) Make the tires contact the ground fully.
CAUTION:
Make the tires contact the ground fully and the
vehicle be in curb weight whenever carrying
out the tightening of bush portions.
16) Tighten the installation bolt of rear housing as-
sembly and lateral link assembly.
Tightening torque:
137 N·m (14 kgf-m, 101 ft-lb)
REAR AXLE
17) Tighten the installation bolt of rear housing as-
sembly and trailing link assembly.
Tightening torque:
90 N·m (9.2 kgf-m, 66 ft-lb)
2. DRUM BRAKE
1) Temporarily tighten the rear axle to strut.
2) Insert the rear drive shaft to rear axle.
NOTE:
Be careful not to damage the inner oil seal lip.
3) Temporarily tighten the axle nut.
4) Using a new self-locking nut, temporarily tighten
the rear housing assembly and lateral link assem-
DS-00064
bly.
5) Using a new self-locking nut, temporarily tighten
the rear housing assembly and trailing link assem-
bly.
( 1 )
DS-00069
6) Tighten the rear housing assembly and strut as-
sembly using a new self-locking nut.
Tightening torque:
196 N·m (20 kgf-m, 145 ft-lb)
7) Using a new self-locking nut, install the rear sta-
bilizer and rear lateral link.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb)
8) Connect the parking brake cable to parking
brake.
9) Clean the brake pipe connection. Using a flare-
nut wrench, connect the brake pipe to wheel cylin-
der.
10) Connect the parking brake cable to lever.
DS-28
DS-00067
DS-00066