Subaru Impreza 2003 Service Manual page 2294

DRIVE SHAFT SYSTEM
4) Using the ST1 and ST2, press a new bearing
into place.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING PULLER
NOTE:
• Always press the outer race when installing the
bearing.
• Be careful not to remove the plastic lock from in-
ner race when installing the bearing.
ST1
5) Using pliers, install the snap ring firmly.
6) Using the ST1 and ST2, press the outer oil seal
until it contacts the bottom of housing.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
FRONT AXLE
ST2
DS-00056
DS-00057
ST1
ST2
DS-00058
DS-22
7) Using the ST1 and ST2, press the inner oil seal
until it contacts the circlip.
ST1 927410000 OIL SEAL INSTALLER
ST2 927400000 HOUSING STAND
ST2
8) Invert the ST and housing.
ST 927400000 HOUSING STAND
9) Apply sufficient grease to the oil seal lip.
Specified grease:
SHELL 6459N
NOTE:
• If specified grease is not available, remove the
bearing grease and apply Auto Rex A instead.
• Do not mix different types of grease.
10) Install the disc cover to housing with three
bolts.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
11) Attach the hub to ST1 securely.
12) Clean dust or foreign particles from the pol-
ished surface of hub.
13) Using the ST2, press the bearing into hub by
driving the inner race.
ST1 927080000 HUB STAND
ST2 927120000 HUB INSTALLER
ST1
DS-00059
ST2
ST1
DS-00060