Subaru Impreza 2003 Service Manual page 2164

REAR SUSPENSION
B: INSTALLATION
Install in the reverse order of removal. Observe the
following instructions.
• Installation of DOJ to differential: <Ref. to DS-39,
INSTALLATION, Rear Drive Shaft.>
CAUTION:
• Replace the self-locking nut and DOJ circlip
with new ones.
• Always use the special tool not to allow the
DOJ splines to damage the side oil seal.
ST 28099PA090 OIL SEAL PROTECTOR
• Always tighten the bushing location when
tires are in full contact with the ground and ve-
hicle is curb weight.
• Secure the bolt head and tighten the nut
when installing the adjusting bolt.
NOTE:
Check the wheel alignment and adjust if necessary.
LATERAL LINK
C: DISASSEMBLY
1) Using the following table as a guide, verify the
type of bushings.
2) Select the ST according to type of bushings
used.
Bushing
Bushing A
Bushing B
Bushing C
Bushing D
(1) Bushing A
(2) FWD: Bushing A, AWD: Bushing B
(3) FWD: Bushing D, AWD: Bushing C
(4) Front
(5) Outside of body
3) Using the ST, press the bushing out of place.
(1) Press
(2) Lateral link
RS-18
ST: INSTALLER & REMOVER SET
927700000
927690000
927700000
927710000
(3)
(2)
(4)
(1)
(1)
(5)
RS-00004
RS-00029