Subaru Impreza 2003 Service Manual page 1575

9) Install the torque the converter clutch to drive
plate.
(1) Tighten the bolts which hold the torque con-
verter clutch to drive plate.
(2) Tighten the other bolts while rotating the en-
gine by using ST.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog the plug onto service hole.
10) Remove the ST.
11) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
12) Lift-up the vehicle.
13) Install the front drive shafts into transmission.
(1) Lift-up the vehicle.
(2) Install the front drive shaft into transmission.
AUTOMATIC TRANSMISSION ASSEMBLY
AT-00102
ST
AT-00105
T1
AT-00691
(3) Drive a new drive spring pin into chamfered
hole of drive shaft.
14) Install the ball joint into housing.
15) Connect the stabilizer link to transverse link,
and tighten the bolts. (Wagon model)
NOTE:
Discard the loosened self-locking nut and replace
with a new one.
Tightening torque:
T1: 30 N·m (3.1 kgf-m, 22.4 ft-lb)
T2: 50 N·m (5.1 kgf-m, 37 ft-lb)
16) Tighten the installing bolts. (Wagon model)
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
4AT-43
AUTOMATIC TRANSMISSION
AT-00685
T2
T1
AT-00692
AT-00809