Subaru Impreza 2003 Service Manual page 1576

AUTOMATIC TRANSMISSION
17) Install the stabilizer link to transverse link. (Se-
dan model)
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
18) Install the shift select cable onto select lever.
<Ref. to CS-14, INSTALLATION, Select Cable.>
19) Install the ATF level gauge guide, and connect
the ATF cooler hoses to pipe.
20) Install the propeller shaft.
<Ref. to DS-16, INSTALLATION, Propeller Shaft.>
21) Install the heat shield cover. (If equipped)
22) Install the rear exhaust pipe and muffler as-
sembly.
Non-turbo model
<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H4SO)-12, INSTAL-
LATION, Muffler.>
2.0 L Turbo model
<Ref. to EX(H4DOTC)-14, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Muffler.>
AUTOMATIC TRANSMISSION ASSEMBLY
AT-00810
AT-00683
AT-00682
23) Install the front and center exhaust pipe. (Non-
turbo model)
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.>
24) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>
25) Install the under cover.
26) Lower the vehicle.
27) Install the ATF level gauge.
28) Connect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
29) Connect the cruise control cable (With cruise
control vehicles).
30) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
31) Install the air cleaner case or air intake cham-
ber. (Non-turbo model)
<Ref. to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.>
32) Install the air intake duct. (Non-turbo model)
<Ref. to IN(H4SO)-6, INSTALLATION, Air Intake
Duct.>
33) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-11, INSTALLATION, Inter-
cooler.>
34) Connect the battery ground cable.
35) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to 4AT-
31, Automatic Transmission Fluid.>
36) Take off the vehicle from lift arms.
37) Check select lever operation.
<Ref. to 4AT-48, INSPECTION, Inhibitor Switch.>
38) Check the ATF level. <Ref. to 4AT-31, Auto-
matic Transmission Fluid.>
39) Check the road test.
<Ref. to 4AT-33, Road Test.>
4AT-44
AT-00693