Subaru Impreza 2003 Service Manual page 2039

ST2 18760AA000 CLAW
ST1
(A) Claw
4) Remove the bearing outer race from side retain-
er.
ST1 398527700 PULLER ASSY
ST2 398527705 CLAW
(A) Side retainer
FRONT DIFFERENTIAL ASSEMBLY
(A)
ST2
MT-00668
ST1
ST2
(A)
MT-00669
6MT-109
MANUAL TRANSMISSION AND DIFFERENTIAL
D: ASSEMBLY
1. DIFFERENTIAL CASE
1) Install the washer to bevel gear.
NOTE:
Face the chamfered side of washer toward gear.
2) Install the bevel gear and bevel pinion gear
washer to differential case, and then insert the pin-
ion shaft.
(D)
(A)
(A) Pinion shaft
(B) Bevel pinion gear
(C) Bevel gear
(D) Washer
3) Check the bevel pinion gear backlash. <Ref. to
6MT-110, BEVEL PINION GEAR BACKLASH, IN-
SPECTION, Front Differential Assembly.>
4) Using the ST, align the pinion shaft and differen-
tial case at their holes, and then drive the straight
pin into holes.
ST 899904100 REMOVER
5) Stake around the hole, and then verify that the
straight pin is secured.
6) Using the ST, install a new speedometer drive
gear and right and left side bearing inner race to dif-
ferential case.
ST1 398437700 INSTALLER
ST2 398497701 SEAT
CAUTION:
Do not apply pressure in excess of 20 kN (2.0
ton, 2.2 US ton, 2.0 Imp ton).
(B)
(C)
(D)
(C)
(B)
MT-00662
ST
MT-00661