Subaru Impreza 2003 Service Manual page 2298

DRIVE SHAFT SYSTEM
NOTE:
If the brake drum is difficult to remove, drive it out
by installing two 8-mm bolts into bolt hole in brake
drum.
8) Remove the brake hose clamp from the rear
strut portion, and separate the brake hose.
(2)
(1) Brake pipe
(2) Brake hose
(3) Brake hose clamp
9) Cover the open end of brake pipe with vinyl
sheet or equivalent to prevent brake fluid from spill-
ing.
10) Disconnect the parking brake cable end.
( 1 )
(1) Cable end
REAR AXLE
DS-00073
(1)
(2)
(3)
(1)
(3)
BR-00126
DS-00065
11) Disconnect the rear stabilizer from rear lateral
link. Remove the bolts which secure the trailing link
assembly to rear housing.
12) Remove the bolts which secure the lateral link
assembly to rear housing.
13) Remove the rear ABS wheel speed sensor
from back plate.
(1) ABS wheel speed sensor
DS-26
DS-00066
DS-00067
( 1 )
DS-00069