Subaru Impreza 2003 Service Manual page 1512

CONTROL SYSTEMS
13) Lower the vehicle.
14) Remove the gear shift lever.
B: INSTALLATION
1. 5MT
1) Install the joint to the transmission and secure
with the spring pin.
2) Insert gear shift lever from room side.
NOTE:
After inserting rod and stay, temporarily put them
onto transmission mount.
3) Lift-up the vehicle.
4) Mount the cushion rubber on body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
(A)
(A) Stay
(B) Cushion rubber
MT GEAR SHIFT LEVER
5) Connect the rod to the joint.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
6) Connect the stay to transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
CS-00054
(B)
7) Install the heat shield cover. (If equipped)
CS-00052
CS-20
(A)
(A) Stay
(B) Rod
(A)
(B)
(A) Stay
(B) Transmission bracket
(B)
CS-00051
CS-00050
AT-00682