Subaru Impreza 2003 Service Manual page 1513

8) Install rear exhaust pipe and muffler.
SOHC model
<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H4SO)-12, INSTAL-
LATION, Muffler.>
SOHC without OBD model
<Ref. to EX(H4SOw/oOBD)-10, INSTALLATION,
Rear Exhaust Pipe.> and <Ref. to EX(H4SOw/
oOBD)-11, INSTALLATION, Muffler.>
DOHC turbo model
<Ref. to EX(H4DOTC)-14, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Muffler.>
9) Install the plate assembly to body.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
10) Install the drive select cable. (Dual-range mod-
el) <Ref. to CS-38, INSTALLATION, Drive Select
Cable.>
11) Install console box. <Ref. to EI-42, INSTALLA-
TION, Console Box.>
MT GEAR SHIFT LEVER
2. 6MT
1) Insert the gear shift lever from room side.
NOTE:
After inserting the rod and stay, temporarily put
them onto transmission mount.
2) Mount the cushion rubber on body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
3) Move the transmission to right side, and then in-
stall the joint COMPL and stay.
Tightening torque:
T1: 11.8 N·m (1.2 kgf-m, 8.7 ft-lb)
T2: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
CS-00157
4) Install the crossmember. <Ref. to 6MT-35, IN-
STALLATION, Transmission Mounting System.>
5) Install the reverse check cable end, washer and
snap pin to reverse check lever.
NOTE:
• Take care to install the snap pin in proper direc-
tion.
CS-21
(A)
T1
T2
(A) Reverse check cable
CONTROL SYSTEMS
CS-00222
CS-00223