Subaru Impreza 2003 Service Manual page 1988

MANUAL TRANSMISSION AND DIFFERENTIAL
14.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-37, REMOVAL, Manual
Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-42, Preparation for Overhaul.>
3) Remove the extension case. <Ref. to 6MT-49,
REMOVAL, Extension Case.>
4) Remove the transfer drive gear.
B: INSTALLATION
1) Install the transfer drive gear.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
2) If the ball bearing, transfer drive gear or snap
ring is replaced, select the transfer drive gear thrust
washer. <Ref. to 6MT-50, ASSEMBLY, Extension
Case.>
3) Install the extension case. <Ref. to 6MT-49, IN-
STALLATION, Extension Case.>
4) Install the manual transmission assembly to ve-
hicle. <Ref. to 6MT-39, INSTALLATION, Manual
Transmission Assembly.>
TRANSFER DRIVE GEAR
C: DISASSEMBLY
1) Remove the snap ring.
2) Using the ST, remove the ball bearing.
ST 499877000
NOTE:
Do not reuse the ball bearing.
MT-00505
D: ASSEMBLY
1) Using the ST, install the ball bearing.
ST1 499247400
ST2 398497701
MT-00505
2) Install the snap ring.
6MT-58
RACE 4-5 INSTALLER
ST
INSTALLER
SEAT
ST2
ST1
MT-00506
MT-00507
MT-00508
MT-00506