Subaru Impreza 2003 Service Manual page 2012

MANUAL TRANSMISSION AND DIFFERENTIAL
24) Set the 6th bush to main shaft, taking care not
to overlap the 6th bush oil hole and main shaft oil
hole.
(A)
(A) 6th bush oil hole
(B) Main shaft oil hole
25) Using the ST, install the 6th bush.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 lmp ton).
26) Make sure the 6th drive gear is smoothly turned
by hand. If not, reassemble.
27) Using the ST, install the inner bearing inner
race.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 lmp ton).
MAIN SHAFT ASSEMBLY
(A)
(B)
MT-00576
ST1
ST2
MT-00577
ST1
ST2
MT-00578
6MT-82
28) Using the ST, install the retainer and outer
bearing inner race.
ST1 18651AA000 INSTALLER
ST2 398177700 INSTALLER
CAUTION:
Do not apply pressure in excess of 40 kN (4.0
ton, 4.4 US ton, 3.9 lmp ton).
NOTE:
• Make sure to install the retainer in proper direc-
tion.
• Press in until there is no backlash in retainer and
where bearing is smoothly turned by hand.
(A) Retainer
(B) Outer bearing inner race
29) Make sure the taper roller bearing is smoothly
turned by hand. If not, replace the taper roller bear-
ing as a set and reassemble.
30) Install the lock washer and new lock nut.
ST1
(B)
(A)
ST2
(A)
MT-00579