Subaru Impreza 2003 Service Manual page 1585

16) Remove the transmission rear crossmember
bolts.
17) Lower the AT jack.
NOTE:
Do not separate the AT jack and transmission.
18) Remove the oil cooler inlet and outlet pipe.
NOTE:
When removing the outlet pipe, be careful not to
lose balls and springs used with retaining screws.
19) Remove the front and rear vehicle speed sen-
sor and torque converter turbine speed sensor.
• Front vehicle speed sensor and torque
converter turbine speed sensor
( B )
(A) Front vehicle speed sensor
(B) Torque converter turbine speed sensor
• Rear vehicle speed sensor
( B )
(A) Rear vehicle speed sensor
(B) Front vehicle speed sensor
20) Remove the oil pan.
FRONT VEHICLE SPEED SENSOR
AT-00043
( A )
AT-00044
( A )
AT-00045
4AT-53
AUTOMATIC TRANSMISSION
21) Remove the duty solenoid connectors and ATF
temperature sensor. Remove the connectors from
clip and disconnect the connectors.
(B)
(C)
(A)
(J)
(G)
(A) Lock-up duty solenoid (Blue)
(B) Transmission ground
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
(I) Transfer duty solenoid (Brown)
(J) Low clutch timing solenoid (Gray)
22) Remove the harness assembly.
B: INSTALLATION
1) Pass the harness assembly through the hole in
the transmission case.
(D)
(E)
(K)
(I)
(H)
(F)
AT-00695
AT-00048