Chrysler Conquest 1988 Service Manual page 109

BODY - Sunroof
23-81
18E24L
mm (in.)
mm(in.)
18E245
18Y391
SERVICE POINTS OF INSTALLATION
26. INSTALLATION OF ROOF LID FEMALE HINGE ASSEM-
BLY
(1) For installation, insert front drain pipe from above, and
rear drain pipe from below.
(2) After installing the roof lid female hinge assembly, apply
the specified sealant to illustrated screw heads.
Specified sealant: MOPAR Vinyl-Acrylic Sealant
Part Number 4026043 or
equivalent
8. INSTALLATION OF ROOF LID REGULATOR ASSEMBLY
With the roof lid fully closed, check to ensure that the
regulator knob marks are in alignment.
4. INSTALLATION OF ROOF LID GLASS
(1) Before installing the headlining, perform a water test by
following procedure.
@ Fully close the roof lid.
@ Spray water against the seam between the roof lid
and roof all around. Hold the hose and roof about _
300 mm (11.8 in.) from the roof and spray water for
more than five minutes.
NOTE
Adjust the water pressure so that the height of water
sprayed will be about 500 mm (19.7 in.) as shown in
illustration.
@ Check for water leaks in the passenger compart-
ment.
@ If water leaks are evident, refer to troubleshooting
and correct.
(2) If there are no leaks after the water test, remove the
regulator, retainer and latch catch and install the
headlining.
(3) Reinstall the regulator, retainer and latch catch.