Chrysler Conquest 1988 Service Manual page 130

s
!!tEzzY
BODY - Headlining
B'
e.
SERVICE POINTS OF REMOVAL
1. REMOVAL OF ROOF SIDE TRIM / 2. FRONT PILLAR
TRIM / 3. REAR PILLAR TRIM / 4. ROLL BAR TRIM / 5.
UPPER QUARTER TRIM
Refer to P.23Y95
I /I II
19Y611
8. REMOVAL OF DOME LIGHT COVER / 9. DOME LIGHT
&g-i
gg
s (1) Use a screwdriver to remove the cover of the dome .~_
light.
(2) Remove the dome light installation screws, and then
pull out tbe~dome light slightly.
(3) Remove the connector, and then remove thti dome -1
light.
.~
-
11. REMOVAL OF ROOF LID REGULATOR ASSEMBLY
Refer to P.2579.
13. 'REMOVAL OF HEADLINING
(1) Remove the mquntingscrews at the rear edge of the
headlining.
(2) Insert the trim stick into the gap between the body and
the headlining from the front of the headlining, then pry ~_
downward to removes the retainers.
-
SERVICE POINT OF INSTALLATION
11. INSTALLATION OF ROOF LID REGULATOR ASSEMBLY
/ 10. ROOF LID GLASS
Refer to P.23-79.