Autosw-Uneq (Vt-Mon); Clear The Autosw-Uneq (Vt-Mon) Alarm; Bat-Fail; Clear The Bat-Fail Alarm - Cisco ONS 15310-CL Troubleshooting Manual

1.7.32 AUTOSW-UNEQ (VT-MON)

1.7.32 AUTOSW-UNEQ (VT-MON)
The automatic path protection switch caused by an unequipped condition (VT-MON) indicates that the
"UNEQ-V" alarm on page 1-145
protection is configured for revertive switching, it reverts to the working path after the fault clears.
Note This condition is only reported if the path protection is set up for revertive switching.

Clear the AUTOSW-UNEQ (VT-MON) Alarm

Complete the
Step 1
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 2
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.

1.7.33 BAT-FAIL

The Battery Fail alarm occurs when the power supply is not detected. This could be because the supply
is removed or is not operational. The alarm does not distinguish between the individual power supplies,
so onsite information about the conditions is necessary for troubleshooting.

Clear the BAT-FAIL Alarm

Step 1 At the site, determine which battery is not present or operational.
Step 2 Remove the power cable from the faulty supply. The "Install Hardware" chapter in the
Cisco ONS 15310-CL and Cisco ONS 15310-MA Procedure Guide contains instructions for installing
both AC (ONS 15310-CL only) and DC (ONS 15310-CL and ONS 15310-MA) power supply cables. To
remove the cable, reverse the appropriate procedure.
Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL
Caution
or ONS 15310-MA.
Step 3 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-32
Default Severity: Minor (MN), Service-Affecting (SA)
SONET Logical Object: VT-MON
"Clear the UNEQ-V Alarm" procedure on page
Default Severity: Major (MJ), Service-Affecting (SA)
SONET Logical Object: PWR
alarm caused automatic path protection switching to occur. If the path
Chapter 1 Alarm Troubleshooting
1-145.
78-17235-01