Integrate With The Realpresence Dma System - Polycom RealPresence 1800 Administration Manual

To configure the required system flags:
1 In RMX Manager, go to Setup > System Configuration > System Configuration.
2 In the MCMS_PARAMETERS_USER
3 To enable machine integration with the RealPresence Resource Manager system, add the
EXTERNAL_CONTENT_DIRECTORY, EXTERNAL_CONTENT_IP, EXTERNAL_CONTENT_PASSWORD, and
EXTERNAL_CONTENT_USER system flags.
4 To allow endpoints included in a cascaded conference to display content (sometimes called content
snatching), add the ENABLE_CONTENT_SNATCH_OVER_CASCADE system flag and set its value to YES.
5 For environments that include NAT Firewall deployments, add the
NUM_OF_INITIATE_HELLO_MESSAGE_IN_CALL_ESTABLISHMENT system flag and set its value to 3.
6 Click OK and when prompted, click Yes.
After the RealPresence Collaboration Server resets, RMX users can access this GAB to add
participants to conferences. However, the RealPresence Collaboration Server uses the Global
Address Book in read-only mode, which means you must add or modify Address Book entries on the
RealPresence Resource Manager system.

Integrate with the RealPresence DMA System

If your organization has the Polycom
Manager system and a RealPresence DMA system along with one or more RealPresence Collaboration
Servers), integrate your RealPresence Collaboration Server with the Polycom
system and set it us as the call control for the conferencing network. Configure the RealPresence DMA
system as the H.323 gatekeeper and/or SIP server, endpoint registrar and virtual meeting room manager.
To integrate the RealPresence Collaboration Server with the RealPresence DMA system:
1 If not already done, add the RealPresence Collaboration Servers and the RealPresence DMA
system as device instances to the RealPresence Resource Manager system. See the RealPresence
Resource Manager Operations Guide for more information.
2 In RMX Manager, go to RMX Management > Rarely Used > IP Network Services.
3 From IP Network Services, double-click Default IP Service and select the required IP Network
Type: H.323 or H.323 & SIP.
4 Go to Gatekeeper tab and from the Gatekeeper drop-down list, select Specify.
5 Enter either the RealPresence DMA system's IP Address or Name (as registered in the DNS).
6 As required, enter the IP Address or Name for an alternate backup gatekeeper.
7 Enter the MCU Prefix in Gatekeeper number, which is the number this network service uses to
register with the RealPresence DMA system gatekeeper. This number is used by H.323 endpoints
as the first part of their dial-in string when dialing the MCU.
8 Complete the other fields as required and then click OK.
Polycom, Inc.
lick New Flag.
tab, c
® RealPresence ® Clariti solution (that is, a RealPresence Resource
Getting Started
® ®
RealPresence DMA
21