Polycom RealPresence 1800 Administration Manual page 310

Active Alarms
Alarm Text
Hot backup: Network issue
Hot Backup: Paired MCU is
unreachable.
Initialization of ice stack failed
Insufficient resources
Insufficient UDP Ports
Internal System configuration during
startup
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP Network Service added
IP Network Service configuration
modified
IP Network Service deleted
IP Network Service not found
IPMC software upgrade in component
IPS 140 test result not received
ISDN/PSTN Network Services
configuration changed
LDAP TLS: Failed to connect to OSCP
responder
Management Network not configured
Missing Central Signaling configuration
Missing Central Signaling IP
configuration
MPL startup failure. Authentication not
received.
Polycom, Inc.
Alarm Description
The number of resources in the license is higher than the actual system
resources.
Check the media cards or insert a media card.
When defining fixed port, the number of defined UDP ports is lower than
the required ports.
Configure additional ports.
System configuration during startup.
Wait until Collaboration Server startup is completed.
IP addresses of Signaling Host and Control Unit are identical.
Assign different IP addresses to the Signaling Host and Control Unit.
IP Network Service was modified. Reset the MCU.
IP Network Service was deleted. Reset the MCU.
IP Service not found in the Network Services list.
Configure the IP Network Service.
New ISDN (audio/video) configuration. Reset the MCU for the change to
take effect.
Note: Applicable to Collaboration Servers 2000/4000/1800
Configure the Management Network.
Configure the central signaling.
Authentication was not received from Switch. Check the switch card.
Active Alarms
289