Polycom RealPresence 1800 Administration Manual page 408

Supported Polycom products
HDX Systems:
• 7000 HD Rev C
• 8000 HD Rev B
• 9006
• 4500
Peripheral Polycom Touch Control
SIP ONLY (no TIP support)
Spectralink wireless phones 8020/8030
Polycom VVX 1500
Polycom VVX 1500 C
KIRK Wireless Server 300/600v3/6000
The following procedures are a summary of the configuration procedures.
The detailed procedures begin with
Flag.
Configuring the Collaboration Server
1 Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag
2 Configuring the Collaboration Server to statically route outbound SIP calls to DMA or CUCM
3 Configuring the Collaboration Server's H.323 Network Service to register with DMA/Resource
Manager gatekeeper
4 Configuring a TIP enabled Profile on the Collaboration Server
5 Configuring an Ad Hoc Entry Queue on the Collaboration Server if DMA is not used
6 Configuring a Meeting Room on the Collaboration Server
7 Configuring Participant Properties for dial out calls
Configuring DMA
If DMA is present in the configuration perform procedures
Configuring a Virtual Meeting Room
route H.323 calls to Collaboration
1 Configuring DMA to route SIP calls to CUCM
2 Configuring a Virtual Meeting Room (VMR)
The procedures for configuring DMA are described in detail in Polycom Unified Communications
Deployment Guide for Cisco Environments.
Configuring the Resource Manager
1 Configuring Resource Manager to route H.323 calls to Collaboration Server
Polycom, Inc.
Appendix - Polycom Open Collaboration Network (POCN)
Procedure 1: Set the MIN_TIP_COMPATIBILITY_LINE_RATE System
(VMR), otherwise skip to procedure
Server.
V3.0.3
Requires TIP option key.
1.3.0
Version(s)
V4.0
V3.3.1
Configuring DMA to route SIP calls to CUCM
Configuring Resource Manager to
and
387