Polycom RealPresence 1800 Administration Manual page 197

General System Flags
Flag Name
ALWAYS_APPLY_CONTENT_THRE
SHOLD
ALWAYS_FORWARD_DTMF_IN_G
W_SESSION_TO_ISDN
AV_MCU_PANORAMIC_LAYOUT_E
NABLED
BLOCK_CONTENT_LEGACY_FOR
_LYNC
BLOCK_NEW_LYNC2013_FUNCTI
ONALITY
Polycom, Inc.
Description
When set to YES, applies the content rate
thresholds configured through the following:
• H264_HD_GRAPHICS_MIN_CONTENT_RATE
• H264_HD_HIGHRES_MIN_CONTENT_RATE
• H264_HD_LIVEVIDEO_MIN_CONTENT_RATE
Default value: YES
Possible values: YES/NO
Note: Requires MCU reset for the settings to take
effect.
When set to YES, the gateway session forwards the
DTMF codes to all ISDN-voice and video
participants.
Default Value: NO
Possible values: YES/NO
Enables panoramic layout on the MCU.
Default value: NO
Possible values: YES/NO
When set to YES, content is not sent to Lync clients
over the video channel. Also includes those with the
Polycom CCS plug-in installed, even when the Send
Content to Legacy Endpoints is enabled. Other
non-Lync legacy endpoints will not be affected by
this flag and will receive content according to the
Send Content to Legacy Endpoints settings in the
conference profile.
When set to NO, content is sent to all Lync clients
over the video channel, including those with the
plug-in installed, even when the Send Content to
Legacy Endpoints is disabled. Other non-Lync
legacy endpoints will not be affected by this flag and
will receive content according to the Send Content to
Legacy Endpoints settings in the conference Profile.
Default value: NO
Possible values: YES/NO
When set to YES, all Microsoft Lync 2013
functionality can be disabled. All Lync 2013 clients,
whether connected directly or through cascading,
will connect using the RTV codec.
Default value: NO
Possible values: YES/NO
System Flags
Platform Add?
HW/VE Yes
HW Yes
HW/VE Yes
HW/VE Yes
Yes
176