Delete A System Flag; System Flags - Polycom RealPresence 1800 Administration Manual

Delete a System Flag

You can delete a system flag from the RealPresence Collaboration Server.
To delete a flag:
1 In RMX Manager, go to Setup > System Configuration > System Configuration.
2 In the MCMS_PARAMETERS_USER
3 Click Yes to confirm and then click OK.

System Flags

The following tables lists the predefined RealPresence Collaboration Server system flags that are
responsible for general system logic. In this case, predefined means that the RealPresence Collaboration
Server can interpret and integrate the value of these system flags into its configuration and logic.
● General System Flags
● CS System Flags
● Password Generation Flags
● Global Address Book Integration Flags
● Auto Layout – Default Layouts in CP Conferences Flags
● Available Layout Flags
General System Flags
Flag Name
ACCEPT_VOIP_DTMF_TYPE
ALLOW_SIREN7_CODEC
Polycom, Inc.
elect a flag to be deleted and click Delete Flag.
tab, s
Description
Defines the type of DTMF tones (inband) or digits
(outband) that the RealPresence Collaboration
Server will accept in VoIP calls depending on the
endpoint's current setting.
Range:
• 0 - Auto (default)
If the endpoint switches from inband to outband and
vice versa, the value of the
SET_DTMF_SOURCE_DIFF_IN_SEC flag
determines the time interval after which both inband
and outband tones/digits will be accepted.
• 1 - Outband (H.245) only
• 2 - Inband only
Prevents disconnection of Lync clients using audio
rates smaller than 42 Kbps, when the Lync server is
configured to allow 33 Kbps audio rate.
Siren 7 audio codec is preferred for SIP/Lync calls,
depending on the value of this flag.
Default value: NO
Possible values: YES/NO
System Flags
Platform Add?
HW/VE Yes
HW/VE Yes
175