Polycom RealPresence 1800 Administration Manual page 230

General System Flags
Flag Name
REMOVE_IP_IF_NUMBER_EXISTS
RESTRICT_CONTENT_BROADCA
ST_TO_LECTURER
RFC2833_DTMF
RMX2000_RTM_LAN
RRQ_WITHOUT_GRQ
RTCP_FIR_ENABLE
Polycom, Inc.
Description
Between the time a conference is scheduled and
when it becomes active, the IP of an endpoint may
change, especially in an environment that uses
DHCP. This flag determines if the E.164 number is to
be substituted for the IP address in the dial string.
Default value: YES - The IP address will be
substituted with the E.164 number.
Possible values: YES/NO
When set to YES, only the conference lecturer may
send content to the conference.
When set to NO, any conference participant can
send content.
Default value: YES
Possible value: YES/NO
Controls the receipt of in-band and out-of-band
DTMF Codes. When set to:
• YES: RealPresence Collaboration Server will
receive DTMF Codes sent in-band.
• NO: RealPresence Collaboration Server receives
DTMF Codes sent out-of-band.
The RealPresence Collaboration Server always
sends DTMF codes in-band (as part of the audio
media stream, but not as RTP events).
Default value: YES
Possible values: YES/NO
Used after installation on and RTM-LAN card to
activate the card. The flag must be set to YES
(RealPresence Collaboration Server 2000).
Possible values: YES/NO
To enable registration, some gatekeepers require
sending first RRQ and not GRQ.
Set the flag to YES, if this behavior is required by the
gatekeeper in your environment.
GRQ (Gatekeeper Request) - Gatekeeper discovery
is the process an endpoint uses to determine which
gatekeeper to register with.
RRQ - registration request sent to the gatekeeper.
Default: NO
Possible values: YES/NO
When set to YES, the Full Intra Request (FIR) is sent
as INFO (and not RTCP).
Default = YES
Possible values: YES/NO
System Flags
Platform Add?
HW/VE Yes
HW/VE No
HW/VE Yes
HW No
HW/VE No
HW/VE Yes
209