23.97 Hz
24 Hz
25 Hz
29.97 Hz
30 Hz
50 Hz
59.94 Hz
60 Hz
pvsp_track_en
is set to enable frame tracking for the PVSP.
used in frame rate conversion mode, video_in_id[7:0],
should also be set.
pvsp_track_en, IO Map, Address 0x1A44[6]
This bit is used to enable tracking of the frequency error to reduce the number of dropped/repeated frames for the Primary VSP.
Function
pvsp_track_en
0
1
svsp_track_en, IO Map, Address 0x1A44[2]
This bit is used to enable tracking of the frequency error to reduce the number of dropped/repeated frames for the Secondary VSP.
Function
svsp_track_en
0
1
2.2.5.
DDR2 Interface
The ADV8003 uses DDR2 memory to enable the de-interlacer, scaler and OSD features. The DDR2 interface on ADV8003 is designed to
meet the JESD79-2F standard.
2.2.5.1. DDR2 Configuration
The controls described in this section are used to configure the ADV8003 DDR2 memory interface.
The first three bits configure the DDR2 memory interface for the external memory configuration. The
size of the attached memory or memories. For example, if using 256 Mbit memory,
Mbit memory,
sdram_size[3:0]
The
word_size[3:0]
and
burst_length[2:0]
connected to the ADV8003. If there is a single DDR2 memory,
and bursts of 8. If there are dual DDR2 memories,
4.
Rev. B, August 2013
Table 9: Frame Tracking
23.97 Hz
24 Hz
Yes
Yes
Yes
Yes
No
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
pvsp_autocfg_output_vid[7:0]
Description
Do not adjust for frequency difference between input and output vertical sync
Adjust for frequency difference between input and output vertical sync
Description
Do not adjust for frequency difference between input and output vertical sync
Adjust for frequency difference between input and output vertical sync
should be set to 0010.
fields must also be configured depending on whether there are single or multiple memories
word_size[3:0]
Output Frame Rate
25 Hz
29.97 Hz
30 Hz
No
No
No
No
No
No
Yes
No
No
No
Yes
Yes
No
Yes
Yes
Yes
No
No
No
Yes
Yes
No
Yes
Yes
svsp_track_en
is set to enable frame tracking for the SVSP. If tracking is to be
word_size[3:0]
and
burst_length[2:0]
and
burst_length[2:0]
113
ADV8003 Hardware Manual
50 Hz
59.94 Hz
No
Yes
No
Yes
Yes
No
No
Yes
No
Yes
Yes
No
No
Yes
No
Yes
(PVSP) and
svsp_autocfg_output_vid[7:0]
sdram_size[3:0]
sdram_size[3:0]
should be set to 0001. If using 512
should be set for a 32-bit word size
should be set for a 64-bit word size and bursts of
60 Hz
Yes
Yes
No
Yes
Yes
No
Yes
Yes
(SVSP)
sets the memory
Need help?
Do you have a question about the ADV8003 and is the answer not in the manual?