Setting The Source Power; Setting The Measurement; Step 3. Perform And Apply The Appropriate Error-Correction; Step 4. Measure The Device Under Test - Agilent Technologies 8719D User Manual

4.
You could also press the Istart_] and Lstoe) keys and enter the frequency range
Note
limits as start frequency and stop frequency values.

Setting the Source Power.

To change the power level to -5 dBm, press:
5.
Note
power ranges, to keep the power setting within the defined range.

Setting the Measurement.

6. To change the number of measurement data points to 101, press:
7. To select the transmission measurement, press:
8. 'RI view the data trace, press:
Step 3. Perform tend apply the appropriate error-correction.
9. Refer to the "Optimizing Measurement Results" chapter for procedures on correcting
measurement errors.
10. To save the instrument state and error-correction in the analyzer internal memory, press:

Step 4. Measure the device under test.

11. Replace any standard used for error-correction with the device under test.
12. 'Ib measure the insertion loss of the bandpass hlter, press:
Step 6. Output the measurement results.
13. To create a hardcopy of the measurement results, press:
Refer to the "Printing, Plotting, and Saving Measurement Results" for procedures on how
to define a print, plot, or save. For information on confIguring a peripheral, refer to the
"Compatible Peripherals" chapter.
24 Making Measurements
. . . . . . . . . . . . . . . . . . . . . . .