Modifying a Command
1. To enter the creation/editing mode, press:
2. To select the particular test sequence you wish to modify (sequence 1 in this example),
press:
The following list is the commands entered in "Creating a Sequence." Notice that for longer
sequences, only a portion of the list can appear on the screen at one time.
Start of Sequence
RECALLPRSTSTATE
LOGMAG
SPAN
SCALE/DIV
AUTO SCALE
3. 'lb change a command (for example, the span value from 50 MHz to 75 MHz) move the
cursor (+) next to the command that you wish to modify, press:
If you use the &) key to move the cursor through the list of commands, the commands are
n
be tested one command at a time.
If you wish to scroll through the sequence without executing each line as you do so, you
n
can press the (JQ key and scroll through the command list backwards.
4. To delete the current command (for example, span value), press:
5. To insert a new value (for example, 75 MHz), press:
Clearing a Sequence from Memory
1. 'lb enter the menu where you can clear a sequence from memory, press:
2. 'Ib clear a sequence, press the softkey of the particular sequence.
M a k i n g
M e a s u r e m e n t s