Agilent Technologies 8719D User Manual page 652

auto sweep time mode
how to set, 5-53
auxiliary channels, 6-8
enabling, 6-41
auxiliary channels;stimulus coupling, 6-43
auxiliary input connector location, l-11
available options, 1-12
averaging, 6-50
sweep-to-sweep, 6-5
averaging changes, 5-58
averaging factor
how to widen, 5-54
Avg status notation, l-7
fault location measurements, 6-125
reflection measurements, 6-12 1
transmission measurements, 6-123
bandwidth
system:how to widen, 5-54
basic measurement sequence and example,
2-3
basic talker (T6), 11-20
battery backup for memory, 12-2
battery life, 4-33
baud rate setting, 11-14
bias inputs and fuses locations, l-11
bias networks, 1 l-4
bias supplies, 11-4
bidirectional lines, 11-18
blanking the display, 6-48
bus device modes, 1 l-2 1
bus structure, 11-17, 11-18
C
11-20
cabinet, 1 l-6
cabinet dimensions, 7-26
cables
HP-IB, 1 l-7
interconnecting, 5-2
interface, 1 l-7
test port return, 11-2
calculate statistics of the measurement data,
2-33
calibrate menu, 6-79
calibrating
noninsertable devices, 5-48
calibration
concepts, 6-56-107
considerations, 6-71
data lost, 12-2
device measurements, 6-71
for non-insertable devices, 6-107
for noninsertable devices, 5-41
in memory, 12-2
interpolated error-correction, 6-78
measurement parameters, 6-71
modifying kits, 6-82
omitting isolation, 6-71
one-port, 6-79
power meter, 5-35, 6-101
procedure to modify a user kit, 6-82
receiver, 5-12
response, 6-79
response and isolation, 6-79
restarting, 6-81
saving data, 6-71
specifying kits, 6-81
standard devices, 6-72
temperature, 12-6
using on multiple analyzers, 12-6
validity of, 6-77
verify performance of, 6-90
calibration arrays
memory requirements, 12-3
calibration array saving, 4-36
calibration constants
entering, 5-28
examining, 5-28
modifying, 5-28
saving modified kit, 5-30
calibration factors entry, 5-36
calibration for mixer measurements, 3-6
calibration kit
class assignments, 6-87
label standard menu, 6-87
modify menu, 6-83
saving modified or user kit, 5-30
specify offset, 6-86
standard definitions, 6-84
terminology, 6-82
calibration kits, 1 l-l
calibration load standards, choosing, 5-6
calibration sets
using, 12-6