Agilent Technologies 8719D User Manual page 175

2. Press m SlZT ~ARl$%&& .PRWl&V3RT PRFKUL~T%% until the correct printer choice
appears:
. . . . . . . . . . . i . b. . , . . . .
q
q
q
Note
If your DeskJet printer does not support the 100 dpi raster format and your
3. Select one of the following printer interfaces:
n
print function as follows:
a. Enter the HP-IB address of the printer, followed by @.
b. Press llocalJ and ~~~~~'-~~~~~~ if there is no external controller conneed to
the HP-IB bus.
c. Press ILocal) and ##$j%&%& ~~~~~~~ if there is an external controller connected to the
HP-IB bus.
Choose ~~~ if your printer has a parallel (centronics) interface, and then confIgure
n
the print function as follows:
until the correct function appears:
n If you choose ~~~~,~~~:~~~,,, the parallel port is dedicated for normal copy
device use (printers or plotters).
n If you c.,oose ~~~~~~~~~~~~~~.. the parael pofi b dedicated for general purpo~
I/O, and cannot be used for printing or plotting.
Choose $$RR#@ if your printer has a serial (RS-232) interface, and then configure the print
n
function as follows:
b. To select the transmission control method that is compatible with your printer, press
appears:
data exchange by transmitting control characters to the network analyzer.
4 . 4 P r i n t i n g ,
converts 100 dpi raster information to 300 dpi raster format.
. . . . . . . A .
,
S a v i n g M e a s u r e m e n t R e s u l t s
. . . . . . . A . . . . s . 2 : . . . . . . . . . % A . : . . . . . : . . . . . . . . 5: