Agilent Technologies 8719D User Manual page 181

If Rm Are Plotting to a Pen Plotter
2. Configure the analyzer for one of the following plotter interfaces:
n
plot function as follows:
a. Enter the HP-IB address of the printer (default is 05), followed by @.
the HP-IB bus.
c. Press m and ~~~~~,~~~;'l~~.~~~~. if there is an external controller connected to the
HP-IB bus.
n Choose ~~~~~~ if your printer has aparallel(centronics)interface, and then conmue
the print function as follows:
until the correct function appears:
n
device use (printers or plotters).
n
I/O, and cannot be used for printing or plotting.
n
.
function as follows:
b. To select the transmission control method that is compatible with your printer, press
appears:
data exchange by transmitting control characters to the network analyzer.
•I If you choose ~~~~~~~ the handshake method allows the printer to control the data
exchange by setting the electrical voltage on one line of the RS-232 serial cable.
Note
firmware or software, it is the fastest transmission control method.
P r i n t i n g , P l o t t i n g , a n d
. . . . . . . . . . . . . . . A / . . A . . . . . ~ ~ ~ ~ ~ ~ . : . : . ; ~ : : : . : : ~ ~ . T. . . . . .
,
. . ; _ . , . , . . . . . . , .
S a v i n g M e a s u r e m e n t R e s u l t s