Agilent Technologies 8719D User Manual page 658

construct a loop structure in a sequence,
2-74
control the test set switch, 5-57
couple and uncouple display markers, 2-23
create a limit test sequence, 2-77
create a test sequence, 2-66
create flat limit lines, 2-44
create single point limits, 2-48
create sloping limit lines, 2-46
decrease frequency span, 5-53
define the plot, 4-12
define the print, 4-5
delete all instrument state files, 4-41
delete an instrument state, 4-41
delete a single instrument state llle, 4-41
delete limit segments, 2-49
divide measurement data by the memory
trace, 2-7
edit a sequence, 2-68
edit limit segments, 2-49
edit power calibration factors, 5-36
enter the power sensor calibration data,
5-36
error-correct for frequency response, 5-9
error-correct for frequency response and
isolation, 5-14
error-correct for full two-port
measurements, 5-2 1
error-correct for one-port reflection
measurements, 5- 18
error-correct for response and isolation
for reflection measurements, 5-14
error-correct for response and isolation
for transmission measurements, 5-16
error-correct for TRL, 5-24
error-correct for TRM, 5-24
error-correct measurements, 5-8
error-correct response for reflection
measurements, 5-9
error-correct response for transmission
measurements, 5-l 1
format a disk, 4-43
gate out responses, 2-81
increase sweep speed, 5-53
insert a sequence command, 2-68
load a sequence from disk, 2-72
maintain test port output power during
sweep retrace, 5-50
make a basic measurement, 2-3
make accurate measurements of electrically
long devices, 5-51
make high power measurements, 2-58
measure conversion loss using tuned
receiver mode, 3-17
measure deviation from linear phase, 2-40
measure devices using the time domain,
2-79
measure electrical length and phase
distortion, 2-37
measure fixed IF mixers, 3-17
measure gain compression, 2-52
measure group delay, 2-40
measure group delay or phase for mixers,
3-24
measure high dynamic range conversion
loss, 3-12
measure magnitude and insertion phase
response, 2-34
measure mixer isolation, 3-33
measure mixer LO to RF isolation, 3-33
measure mixers, 3-l
measure reflection response in time domain,
2-83
measure reverse isolation and gain, 2-56
measure swept RF/IF mixers, 3-7
measure transmission response in time
domain, 2-79
modify a sequence command, 2-69
modify calibration standards, 5-29
modify TRL calibration standards, 5-30
modify TRM calibration standards, 5-32
offset limit lines, 2-51
output a single page of values, 4-30
output multiple plots to a single page using
a printer, 4-25
output plot llles, 4-19
output plot flies from a PC to a plotter,
4-22
output plot files from a PC to a printer,
4-23
output single page plots using a printer,
4-24
output the entire list of values, 4-31
plot a measurement to disk, 4-19
plot measurements in page quadrants,
4-28
plot multiple measurements on a full page,
4-26
plot multiple measurements per page,
4-17, 4-26
plot one measurement per page, 4-16
plot to an HPGL compatible printer, 4-18
power meter calibrate, 3-6
print a sequence, 2-72
4-6
print one measurement per page, 4-6
print or plot list values or operating
parameters, 4-30