Agilent Technologies 8719D User Manual page 577

BAD FREQ FOR HARMONIC OR FREQ OFFSET
Error Number You turned on time domain or recalled a calibration that resulted in start and
181 stop frequencies that are beyond the allowable limits.
BATTERY FAILED. STATE MEMORY CLEARED
Error Number The battery protection of the non-volatile CMOS memory has failed. The CMOS
183 memory has been cleared. Refer to the
State and Memory Allocation, n for more information about the CMOS memory.
BATTERY LOW! STORE SAVE REGS TO DISK
Error Number The battery protection of the non-volatile CMOS memory is in danger of failing.
If this occurs, all of the instrrm-tent state registers stored in CMOS memory will
be lost. Save these states to a disk and refer to the
"Preset State and Memory Allocation, n for more information about the CMOS
memory.
BLOCK INPUT ERROR
Error Number The analyzer did not receive a complete data transmission. This is usually
34 caused by an interruption of the bus transaction. Clear by pressing the LLocal)
key or aborting the I/O process at the controller.
BLOCK INPUT LENGTH ERROR
Error Number The length of the header received by the analyzer did not agree with the size
35 of the internal array block. Refer to the
Programmer's Guide for instructions on using analyzer input commands.
CALIBRATION ABORTED
Error Number You have changed the active channel during a calibration so the calibration in
74 progress was terminated. Make sure the appropriate channel is active and
restart the calibration.
104 Error Messafles
HP 8719D/ZOD&?2D Network Anulgm
HP 8719D/2OD!22D Network