Agilent Technologies 8719D User Manual page 62

11. Perform a full 2-port calibration on channel 2:
Press (ETJ ~~~~~~ HIT& 'I'LL ,3-PIIRT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . i . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Make sure you connect the calibration standards to the Rx port of the test
Note
adapter (or a cable attached to it) for the FORWARD calibration, and the
Antenna port for the REVERSE calibration.
12. When the calibration has been completed, save this state in the analyzer:
13. Connect the DUT to the test adapter.
14. Enable both auxiliary channels 3 and 4:
16. Set the measurement parameters (channel 1 should be active):
This is the transmission of the Tx-to-Ant path.
This is the reflection at the T
This is the transmission of the Ant-to-Rx path.
This is the reflection at the Rx port.
The display will be similar to Figure 2-7.
2-14 Making Measurements
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
, . . , . : : . . < . : .
port.
X