Agilent Technologies 8719D User Manual page 268

2. Set the IF bandwidth to change the sweep time.
The following table shows the relative increase in sweep time as you decrease system
bandwidth. The characteristic values in the following table were derived using 51
measurement points.
By reducing the averaging factor (number of sweeps) or switching off averaging, you can
increase the analyzer's measurement speed. The time needed to compute averages can also
slow the sweep time slightly, in narrow spans
2. Enter an averaging factor that is less than the value displayed on the analyzer screen and
press (xl).
3. If you want to sdtc., off averaging, press 1Avg) ~~~~~~~~~~.
2. Enter a number of points that is less than the value displayed on the analyzer screen and
press (QiJ.
5-54 Optimizing Measurement Results
1 The listed sweep times correspond
to a preset state for the full span,