Agilent Technologies 8719D User Manual page 635

Instrument state1
W Four-channel instrument state
Graphics
G
D Error corrected data
Raw data
Formatted data
F
c Cd
Cal data, channel 1
1
Cal data, channel 2
2
Memory trace data
Error corrected data (S2P)3
S
1 These are two-channel instrument states readable by previous -ware versions.
2 Files Rl through R8 will be saved if a full two-port calibration is active. If a fuIl two-port
calibration is not active only Rl will be saved for Channel 1 and 3, and R5 for Channel 2 and
4.
3 These files are written only when a 2-port error correction (full 2-port or TRL) has been
applied.
If correction is on at the time of an
that inactive calibrations are
analyzer from disk, the stimulus and response parameters are restored first. If correction is on
for the loaded state, the analyzer will load a calibration set from disk that carries the same title
as the one stored for the instrument state.
Definition
o t o c
external store, the calibration set is stored to disk. (Note
not stored to disk.) When an instrument state is loaded into the
Definition
1 Display graphics
0
Graphics index
1 Channel 1
2 Channel 2
3 Channel 3
4 Channel 4
Channel l/3, raw arrays 1 to 42
Channel 2/4, raw arrays 6 to 8
1
Channel 1
2 Channel 2
3 Channel 3
4 Channel 4
Cal kit
K
0
A Coefficient 10
B
same as channel 1
1 Channel 1
2 Channel 2
3 Channel 3
4 Channel 4
Channel 1
1
2 Channel 2
Preset State end Memory Allocation 12-5