Running a Limit Test
1. To access the limits menu and activate the limit lines, press:
Reviewing the Limit Line Segments
The limit table data that you have previously entered is shown on the analyzer display.
2. To verify that each segment in your limits table is correct, review the entries by pressing:
3. To modify an incorrect entry, refer to the "Editing Limit Segments" procedure, located
earlier in this section.
Activating the Limit l&t
4. To activate the limit test and the beep fall indicator, press:
Note
approximately 50 ms of sweep cycle time. Because the limit test will still work
The limit test results appear on the right side on the analyzer display. The analyzer indicates
whether the filter passes or fails the dellned limit test:
A Tl'L signal on the rear panel BNC connector "LIMIT TEST" provides a pass/fail (5 V/O V)
q
indication of the limit test results
M e a s u r e m e n t s
. . . . . . . . . . . . . . _ . . .