Agilent Technologies 8719D User Manual page 520

provides a measurement calibration for reflection-only
measurements of one-port devices or properly terminated
two-port devices, at port 2 of an S-parameter test set or the test
port of a transmission/reflection test set.
is used to enter the standard numbers for the first class
required for an &Z l-port calibration. (For default cal kits, this
is the open.)
is used to enter the standard numbers for the second class
required for an E&Z l-port calibration. (For default cal kits, this
is the short.)
is used to enter the standard numbers for the third class
required for an SZZ l-port calibration. (For default kits, this is
the load.)
measures the short circuit TRL/LRM calibration data for
PORT 2.
saves the modified version of the color set.
provides access to all the menus used for saving and recalling
instrument states in internal memory and for storing to, or
loading from, external disk. This includes the menus used to
and to clear data from the registers or purge files from disk.
stores the user-modified or user-defined kit into memory, after
it has been modified.
selects binary format for data storage.
changes the response value scale per division of the displayed
trace. In polar and Smith chart formats, this refers to the full
scale value at the outer circumference, and is identical to
reference value.
toggles between two selections for plot scale, FULL and GRAT.
is the normal scale selection for plotting on blank paper. It
includes space for all display annotations such as marker
values, stimulus values, etc. The entire display fits within the
maintaining the exact same aspect ratio as the display.
expands or reduces the horizontal and vertical scale so that the
lower left and upper right graticule comers exactly correspond
to the user-delined Pl and P2 scaling points on the plotter. This
is convenient for plotting on preprinted rectangular or polar
forms (for example, on a Smith Chart).
Key Definitions 939