Limit Test Example Sequence - Agilent Technologies 8719D User Manual

Limit Test Example Sequence

This measurement example shows you how to create a sequence that will branch the sequence
according to the outcome of a limit test. Refer to "Testing a Device with Limit Lines," located
earlier in this chapter, for a procedure that shows you how to create a limit test.
For this example, you must have already saved the following in register 1:
device measurement parameters
n
an active limit test
n
1. To create a sequence that will recall the desired instrument state, perform a limit test, and
branch to another sequence position based on the outcome of that limit test, press:
This will create a displayed list for sequence 1, as shown:
start of sequence
RECALL KEG 1
IF LIMIT TEST PASS THEN DO
SEQUENCE 2
IF LIMIT TEST FAIL
SEQUENCE 3
2. To create a sequence that stores the measurement data for a device that has passed the limit
test, press:
This will create a displayed list for sequence 2, as shown:
Start of Sequence
INTERNAL DISK
DATA ARRAY
ON
FILENAME
FILE 0
SAVE FILE
M a k i n g