Agilent Technologies 8719D User Manual page 102

(Menu
)
13. lb place the marker exuctZ@ on a measurement point, press:
14. To set the CW frequency before going into the power sweep mode, press:
16. Tlb choose the power range, press:
17. Enter the start and stop power levels for the sweep.
Now, channel 1 is displaying a gain compression curve. (Do not pay attention to channel 2
at this time.)
18. To maintain the calibration for the CW frequency, press:
Now channel 2 displays absolute output power (in dDm) as a function of power input.
. . . i . > ; . . u ; ; ; ; ; . . . . i , , . , . , . : : .. . . . . . L ; ; . . ~ . . . . . . . . . . . . . . ~ ~ ~ . . . . . A . :
Press @iii) (TJ Lxl] to change the scale of channel 1 to 1 dD per division.
23
.
M a k i n g M e a s u r e m e n t s
channel stimulus by