Agilent Technologies 8719D User Manual page 519

eliminates the need to restart a calibration sequence that was
interrupted to access some other menu. This softkey goes back
to the point where the calibration sequence was interrupted.
measures the reverse isolation of the calibration standard.
lets you enter a label for the reverse match class. The label
appears during a calibration that uses this class.
specifies which standards are in the reverse match class in the
calibration kit.
is used to enter the standard numbers for the reverse match
(thru) calibration. (For default kits, this is the thru.)
lets you enter a label for the reverse transmission class The
label appears during a calibration that uses this class.
specifies which standards are in the reverse transmission class
in the calibration kit.
is used to enter the standard numbers for the reverse
transmission (thru) calibration. (For default kits, this is the
adjusts the source frequency higher than the LO by the amount
of the LO (within the limits of the analyzer).
adjusts the source frequency lower than the LO by the amount
of the LO (within the limits of the analyzer).
draws a quarter-page plot in the lower right quadrant of the
draws a quarter-page plot in the upper right quadrant of the
resets the seconds counter to zero in real-time clock.
presents the S-parameter menu, which is used to define
the input ports and test set direction for S-parameter
measurements.
provides a measurement calibration for reflection-only
measurements of one-port devices or properly terminated
two-port devices, at port 1 of an S-parameter test set or the test
port of a transmission/reflection test set.
is used to enter the standard numbers for the first class
required for an SI1 l-port calibration. (For default cal kits, this
is the open.)
is used to enter the standard numbers for the second class
required for an SI1 l-port calibration. (For default cal kits, this
is the short.)
is used to enter the standard numbers for the third class
required for an SI1 l-port calibration. (For default kits, this is
the load.)
measures
the short circuit TRULRM calibration data for PORT
1.