Agilent Technologies 8719D User Manual page 660

information messages, 10-l
initializing
DOS, 11-7
LIF, 11-7
input ports menu, 6-30
inserting a sequence command, 2-68
insertion phase and magnitude response
measurement, 2-34
instrument modes, 6-115-118
frequency offset, 6-l 16
network analyzer, 6-l 15
tuned receiver, 6-l 15
instrument state, 6-108-l 14
contents, 4-33
deleting ail files, 4-41
deleting a single file, 4-41
memory requirements, 12-3
saving, 4-33, 4-35
instrument state function block location, l-5
instrument state in memory, 12-1
instrument states in memory, 12-2
interconnecting cables, 5-2
interface
cables, 1 l-7
GPIO, l-10
interface addresses, 1 l-22
interface clear (IFC) control line, 11-18
interface configuration
HP-IB, 11-13
serial, 11-14
interface function codes, 7-23
interface functions
controller, 11-17
listener, 11-17
talker, 11-17
interface port
configuration, 11-12
internal memory data retention, 4-33
internal memory register contents, 4-33
interpolated calibration
restoring, 12-6
interpolated error-correction, 5-7, 6-78
interpolated error correction, 2-9
isolation, 6-59
isolation calibration, 6-79
isolation measurements for mixers, 3-33
isolation (reverse) and gain measurement,
2-56
K
keyboard connector, l-10
keyboard (DIN), 7-25
keyboards, 1 l-8
key definitions, 9-l
key menu maps, 8-l
keys
active channel. 6-8
6 - 4 1
entry, 6-10-11
6 - 1 1
instrument state, 6-108-114
Menu , -
response function, 6-27-52
step, 6-11
stimulus function, 6-12-26
units terminator, 6-10
keys referenced to front panel access key,
9-75
key to HP-IB command, 9-54
kit label, 5-32, 5-34
knob
RPG, 6-11
label class menu, 6-89
label kit, 5-32, 5-34
label kit menu, 6-89
label the classes, 5-32, 5-34
LCD, l-6
LEO (no extended listener capabilities), 11-20
LIF format, 11-7
limit lines, 6-112
limits
editing, 6-l 13
offset, 6-l 14
limit segments
editing, 6-113
Iimit test connector location, l-11
Iimit test example sequence, 2-77
Iimit testing, 2-43
activating, 2-50
creating flat Iimit lines, 2-44
creating single point limits, 2-48
creating sloping iimit lines, 2-46
deleting limit segments, 249
editing hit segments, 2-49
offsetting Iimit lines, 2-51
pass/fail indicators, 2-51