Agilent Technologies 8719D User Manual page 576

ANALOG INPUT OVERLOAD
Error Number The power level of the analog input is too high. Reduce the power level of the
60 analog input source.
ANOTHER SYSTEM CONTROLLER ON HP-IB BUS
Error Number You must remove the active controller from the bus or the controller must
37
relinquish the bus before the analyzer can assume the system controller mode.
ASCII: MISSING 'BEGIN' STATEMENT
Error Number The citiiile you just downloaded over the HP-IB or via disk was not properly
193 organized. The analyzer is unable to read the "BEGIN" statement.
ASCII: MISSING 'CITIFILE'STATEMENT
Error Number The citiille you just downloaded over the HP-IB or via disk was not properly
194 organized. The analyzer is unable to read the "CITIFILE" statement.
ASCII: MISSING 'DATA' STATEMENT
Error Number The citillle you just downloaded over the HP-IB or via disk was not properly
195 organized. The analyzer is unable to read the "DATA" statement.
ASCII: MISSING 'VAR' STATEMENT
Error Number The citifile you just downloaded over the HP-IB or via disk was not properly
196 organized. The analyzer is unable to read the "VAR" statement.
AVERAGING INVALID ON NON-RATIO MEASURE
Error Number You cannot use sweep-to-sweep averaging in single-input measurements
13 Sweep-sweep averaging is valid only for ratioed measurements (A/R, B/R, A/B,
and S-parameters). You can use noise reduction techniques, such as narrower
IF bandwidth, for single input measurements.
Error Messages 1 O-3