Agilent Technologies 8719D User Manual page 495

adjusts the electrical delay to balance the phase of the DUT. It
simulates a variable length lossless transmission line, which can
be added to or removed from a receiver input to compensate
for interconnecting cables, etc. This function is similar to
the mechanical or analog "line stretchers" of other network
analyzers. Delay is annotated in units of time with secondary
labeling in distance for the current velocity factor.
causes the instrument to beep once.
terminates the HP-GL "LB" command.
sets the TI'L output on the test set interconnect to normally
high with a 10 ps pulse high at the end of each sweep.
sets the 'ITL output on the test set interconnect to normally low
with a 10 ps pulse low at the end of each sweep.
deletes the entire title.
runs the selected service test.
(Option 085 only) switches the internal REF'LOCK SELECT
switch on or off. This allows the analyzer to receive its R
channel input through its R CHANNEL IN port or from its own
internal source.
selects the auto external source mode.
selects the manual external source mode.
is similar to the trigger on sweep, but triggers each data point in
a sweep.
is used when the sweep is triggered on an externally generated
signal connected to the rear panel EXT TRIGGER input.
External trigger mode is allowed in every sweep mode.
Use this feature to add electrical delay (in seconds) to extend
the reference plane at input A to the end of the cable. This is
used for any input measurements including S-parameters.
adds electrical delay to the input B reference plane for any B
input measurements including S-parameters.
extends the reference plane for measurements of S11, S21, and
extends the reference plane for measurements of &, S12, and
toggles the reference plane extension mode. When this function
is on, all extensions dellned above are enabled; when off, none
of the extensions are enabled.
selects an (optional) external disk drive for SAVE/RECALL.
leads to a series of service tests.
appears during sequence modification, when external disk
is selected. PILE0 is the default name. A new name can be
entered when you save the state to disk.