Edit Configuration File; Editable Configuration File Upload - ZyXEL Communications MSC1000G User Manual

37.3.2 Edit Configuration File

Open the
config.dat
configuration.
Note: Ensure that any changes you make to the commands in the configuration file
correspond to the commands documented in this User's Guide. The system user
password is encrypted and you cannot edit it in a text editor.
$$ system configuration file
[version]
1.00
$$ msc configuration
[confuser]
sys user auth 3
sys user set admin d4:88:dd:79:63:7c:78:11:87:92:cb:3b:c5:41:0c:21 high
sys user enable admin
sys user server 0.0.0.0 1812 1234
[confsyslog]
sys syslog disable
sys syslog server local1 0.0.0.0
sys syslog server local2 0.0.0.0
sys syslog server local3 0.0.0.0
sys syslog server local4 0.0.0.0
sys syslog server local5 0.0.0.0
sys syslog server local6 0.0.0.0
sys syslog server local7 0.0.0.0
[msc]
sys info hostname TGE1
sys snmp getcommunity public
sys snmp setcommunity public
sys snmp trapcommunity public
sys server port telnet 23

37.3.3 Editable Configuration File Upload

You can upload the configuration file by following the steps below.
Use an FTP or SFTP client to connect to the IES.
C:\> ftp <IES IP address>
Type your user name and press [ENTER].
User (123.23.15.86:(none)): admin
Enter the management password (1234 by default).
Password: 1234
230 Logged in
ftp> put xxx.dat config-0
Management Switch Card User's Guide
file via a text editor (see the following example) and edit to the desired
Chapter 37 Firmware and Configuration File Maintenance
1099