Configuring Basic Network Settings - Avaya Scopia XT Telepresence Deployment Manual

Configuring the XT Telepresence
5. Press 2 to highlight the triangle in the bottom right corner in blue.
6. Adjust the image position in the same way, until all sides of the triangle border are visible,
then press ok/menu.
7. To continue with the Quick Setup Wizard, select Next (see
Settings on page 56).
If your monitor is 4K, graphic adjustment is not applied.
Related links
Configuring Basic Settings with the Quick Setup Wizard

Configuring Basic Network Settings

About this task
This procedure describes how to set up the basic network settings and the IP address of the XT
Series as part of the Quick Setup Wizard. To modify advanced network settings, see Deployment
Guide for Avaya Scopia
Procedure
1. Access the Quick Setup Wizard from the endpoint, as described in
Settings with the Quick Setup Wizard
2. Enter the following values:
January 2017
®
XT Series.
on page 51, and skip to this step.
Figure 48: Defining IP Settings
®
Avaya Scopia XT Telepresence Deployment Guide
Comments on this document? infodev@avaya.com
Configuring Basic Network
on page 51
Configuring Basic
56