Using The J-Web Interface; Starting The J-Web Interface - Juniper J-series Services Router J2320 Getting Started Manual

Using the J-Web Interface

This section contains the following topics:
For more information about using the J-Web interface, see the J-Web Interface User
Guide.

Starting the J-Web Interface

To start the J-Web interface:
1.
NOTE: If the Services Router is running the worldwide version of the JUNOS Internet
software and you are using the Microsoft Internet Explorer Web browser, you must
disable the
2.
3.
NOTE: The default username is
initial configuration or the system does not accept the configuration.
To explicitly terminate a J-Web session at any time, click Logout in the top pane.
Starting the J-Web Interface on page 81
J-Web Layout on page 82
Elements of the J-Web Interface on page 83
Navigating the J-Web Interface on page 85
J-Web Sessions on page 88
Launch your HTTP-enabled or HTTPS-enabled Web browser.
To use HTTPS, you must have installed a certificate on the Services Router and
enabled HTTPS.
option in the Web browser to access the Services Router.
Use SSL 3.0
After http:// or https:// in your Web browser, type the hostname or IP address
of the Services Router and press Enter.
The J-Web login page appears.
On the login page, type your username and password, and click Log In.
To correct or change the username or password you typed, click Reset, type the
new entry or entries, and click Log In.
The J-Web Quick Configuration>Set Up or Monitor>System page appears.
Chapter 4: Services Router User Interface Overview
root with no password. You must change this during
Using the J-Web Interface
81