Monitoring Rsvp Session Information; Monitoring Mpls Rsvp Interfaces Information - Juniper J-Series Administration Manual

Monitoring MPLS Interfaces
To view the interfaces on which MPLS is configured, select
Monitor>MPLS>Interfaces, or enter the following CLI command:
show mpls interface
Table 64 on page 131 summarizes key output fields in the MPLS interface information
display.
Table 64: Summary of Key MPLS Interface Information Output Fields
Field Values
Interface Name of the interface on which MPLS is
configured.
State
State of the specified interface:
Administrative groups Administratively assigned colors of the MPLS link
configured on the interface.
Monitoring MPLS LSP Information
To view all label-switched paths (LSPs) configured on the Services Router, including
all inbound (ingress), outbound (egress), and transit LSP information, select
Monitor>MPLS>LSP Information, or enter the following CLI command:
show mpls lsp
Table 65 on page 131 summarizes key output fields in the MPLS LSP information
display.
Table 65: Summary of Key MPLS LSP Information Output Fields
Field Values
Ingress LSP Information about LSPs on the inbound router.
Each session has one line of output.
Egress LSP Information about the LSPs on the outbound
router. Each session has one line of output.
Transit LSP Number of LSPs on the transit routers and the
state of these paths.
To Destination (outbound router) of the session.
Monitoring RSVP Session Information on page 133
Monitoring MPLS RSVP Interfaces Information on page 134
Up or Dn
Chapter 7: Monitoring the Router and Routing Operations
Additional Information
(down).
Additional Information
MPLS learns this information by querying RSVP,
which holds all the transit and outbound session
information.
MPLS learns this information by querying RSVP,
which holds all the transit and outbound session
information.
Using the Monitoring Tools
131