Starting The J-Web Interface; J-Web Layout - Juniper J2300 Getting Started Manual

Starting the J-Web Interface

To start the J-Web interface:
1.
NOTE: If the Services Router is running the worldwide version of the JUNOS Internet
software and you are using the Microsoft Internet Explorer Web browser, you must
disable the
2.
3.
NOTE: The default username is
initial configuration or the system does not accept the configuration.
To explicitly terminate a J-Web session at any time, click Logout in the top pane.

J-Web Layout

Each page of the J-Web interface is divided into the following panes
shown in Figure 36 and Figure 37:
Starting the J-Web Interface on page 67
J-Web Layout on page 67
J-Web Sessions on page 72
Launch your HTTP-enabled or HTTPS-enabled Web browser.
To use HTTPS, you must have installed a certificate on the Services Router
and enabled HTTPS.
option in the Web browser to access the Services Router.
Use SSL 3.0
After or in your Web browser, type the hostname or IP address
http:// https://
of the Services Router and press Enter.
The J-Web login page appears.
On the login page, type your username and password, and click Log In.
To correct or change the username or password you typed, click Reset, type
the new entry or entries, and click Log In.
The J-Web Quick Configuration>Set Up (see Figure 36) or Monitor>System
page appears.
Top pane—Displays identifying information and links.
Services Router User Interface Overview
with no password. You must change this during
root
Using the J-Web Interface
67