Installing A Qsfp28 Transceiver - Juniper ACX6160 Hardware Manual

CAUTION: Do not bend fiber-optic cables beyond their minimum bend radius. An arc
smaller than a few inches in diameter can damage the cables and cause problems that
are difficult to diagnose.
4. Remove the cable connected to the transceiver. Cover the transceiver and the end of each fiber-optic
cable connector with a rubber safety cap immediately after disconnecting the fiber-optic cables.
5. To remove the transceiver:
a. Loosen the screws on the transceiver by using your fingers.
b. Grasp the screws on the transceiver and gently slide the transceiver approximately 0.5 in.
(1.3 cm) straight out of the port.
CAUTION: To prevent electrostatic discharge (ESD) damage to the transceiver, do
not touch the connector pins at the end of the transceiver.
6. By using your fingers, grasp the body of the transceiver and pull it straight out of the port.
7. Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat, stable surface.
8. Place the dust cover over the empty port or install the replacement transceiver.

Installing a QSFP28 Transceiver

The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs). You can remove and replace them without powering off the device or disrupting the device
functions.
NOTE: After you insert a transceiver or after you change the media-type configuration, wait for
6 seconds for the interface to display operational commands.
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
77