Related
Documentation
Replacing a PC Card in a T640 Routing Engine
Removing a T640 PC Card
Copyright © 2017, Juniper Networks, Inc.
Install the Routing Engine.
6.
You can view the the SDRAM configuration and verify the DIMM was installed correctly
7.
by issuing the
show chassis routing-engine
Figure 159: Installing the DIMM Module
T640 Routing Engine Description on page 36
Replacing a T640 Routing Engine on page 317
To replace a PC Card, perform the following procedures:
Removing a T640 PC Card on page 325
1.
Installing a T640 PC Card on page 326
2.
The PC Card is located in the slot labeled
the PC Card (see
Figure 160 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Remove the Routing Engine cover by loosening the captive screws on the corners of
3.
its faceplate.
Chapter 27: Replacing Host Subsystem Components
command.
on the Routing Engine. To remove
PC CARD
326):
325