Powering On The T320 Router; Figure 64: Connecting Dc Power To The T320 Router - Juniper Core Router T Series Hardware Manual

Related
Documentation

Powering On the T320 Router

Copyright © 2018, Juniper Networks, Inc.
Tighten the cable restraint captive screw to hold the power cables in place.
10.
Verify that the ground and power cabling are correct, that they are not touching or
11.
blocking access to router components, and that they do not drape where people could
trip on them.
Replace the clear plastic cover over the terminal studs on the faceplate.
12.

Figure 64: Connecting DC Power to the T320 Router

Overview of Connecting the T320 Router to External Devices on page 153
Connecting the T320 Grounding Cable on page 151
T320 General Electrical Safety Guidelines and Electrical Codes on page 353
Site Electrical Wiring Guidelines for Juniper Networks Devices on page 361
To power on the router:
Verify that the power supplies are fully inserted in the chassis and that the captive
1.
screws on their faceplates are tightened.
Verify that the source power cables are connected to the appropriate terminal: the
2.
positive (+) source cable to the return terminal (labeled
(–) source cable to the input terminal (labeled
Verify that an external management device is connected to one of the Routing Engine
3.
ports on the CIP (
AUXILIARY
connecting management devices, see
External Devices" on page
Turn on the power to the external management device.
4.
Chapter 21: Providing Power to the T320
–48V
, , or
CONSOLE ETHERNET
"Overview of Connecting the T320 Router to
153.
) and the negative
RETURN
).
). For more information about
163